Ask Proxima M9 Uživatelská příručka

Contents1EnglishEnglishUnpacking ...

Getting Ready10Before performing any of the operations in this section, make sure you first set up the projector and connect to an output device.AC Po

11Getting ReadyEnglishz If the Eco Mode is turned on, the LAMP indicator will light green when warm up starts.z If the projector is hot when you plug

Getting Ready12z When you turn off the projector, the lamp goes out and the projector goes into a cool down state. Note that you will not be able to t

13Projector BasicsEnglishProjecto r Basicsz For detailed information about projection operations, see the Reference Guide on the CD-ROM that comes wit

Projector Basics14Auto Adjustment of an RGB ImageWhen the input source is RGB (computer), the projector automatically adjusts vertical and horizontal

15Using the Setup MenuEnglishUsing the Setup MenuPressing the [MENU] key while an image is being projected displays the setup menu on the projected im

16TroubleshootingTr oubleshootingThe status of the indicators lets you know the current operational status of the projector. This section provides det

17TroubleshootingEnglishPOWERTEMPLAMP: Amber flashing  Amber steady: Red flashing (1-second interval)  Turns off:–Power has turned off automatically

Troubleshooting18POWERTEMPLAMP: Green steady:–:–Zoom and focus cannot be performed due to some trouble in the optical drive circuit. Turn off the proj

19TroubleshootingEnglishPOWERTEMPLAMP: Green steady:–: Red flashing (1-second interval)It is time to replace the lamp. Replace the lamp following the

2UnpackingUnpackingAs you unpack the projector, check to make sure that all of the items listed below are present.The CD-ROM that comes with the proje

Troubleshooting20Check the following items whenever you experience any problem with the projector.Projector TroubleshootingProblem Cause and Recommend

21TroubleshootingEnglishTry performing the following steps, which can return the projector to normal operation.1. Press the [ ] (power) key to turn of

22Service and SupportService and Suppo rtQuestions? We're here to help!Visit us at: www.askproxima.com/serviceWe're here to support you with

23Service and SupportEnglishCanadaThis Class A digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe A est conforme à

ASK M9_UG_E.book Page 24 Tuesday, October 23, 2007 5:32 PM

3General GuideEnglishGeneral Guide[Front/Top/Left Side][Key and Indicator Panel]* The projector’s enter key does not have anything printed on it. When

General Guide4[Bottom][Back, Terminals]z The anti-theft lock hole is provided for connection of an anti-theft chain. Warningz In the unlikely event of

5General GuideEnglishThe remote control unit comes loaded with a test battery. Before using it for the first time, remove the battery insulation sheet

General Guide6Before you can use the remote controller for the first time, you need to load the battery that comes with it.Replacing the Remote Contro

7Getting ReadyEnglishGetting ReadyLocate the projector on a desk, table, or stand that is firm and level. Make sure to allow sufficient space around t

Getting Ready8You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can also make fine adjustments to the left and ri

9Getting ReadyEnglishYou can use the projector to project an image of video output from a computer.z Always turn off the projector and the computer be